Edit Omnisat Dome Channel Information
Simply follow the instructions below...
|
|
Step 1
Press the (MENU) button on the remote control. Using the Left or Right buttons on the remote, scroll around until "INSTALLATION" is highlighted and press (OK)
|
|
Step 2
Once in the "INSTALLATION" menu, you will need to scroll down the screen until "Manual Edit/Search" is highlighted then press (OK)
|
|
Step 3
When asked for a PIN number, use the remote to type in four zeros (0000) to proceed to the next step.
If you have changes the PIN number, type this number in instead.
|
|
Step 4
Press the (RED) button on the remote to scan the transponder for the new channel details, this will take a few seconds and then a list of channels shouls appear.
|
|
Step 5
Using the up and down buttons on the remote, scroll to the required channel. When highlighted you will then need to press the "YELLOW" button on the remote to "replace currrent" channel with the highlighted.
|
|
Step 6
When the changes have been made you will need to now (EXIT) out of the menu. Before you are able to view your program, you will be asked whether you would like to save changes, for this I would press (OK) on your remote.
|
|
Set Up Complete
After you have pressed (OK) to save any changes you have made, the "Saving.. Please Wait" screen will appear for a few seconds to confirm it is saving, if this screen does not appear you have either selected "NO" to saving changes or have not made any alteration.
|
|
